News

Fireproof clothing business fined $135,000 for inadequate chemical safety systems

A FIREPROOF clothing business has been fined $135,000 after a worker suffered corrosive chemical burns to the face.

WorkSafe Victoria claims the incident occurred six weeks after a chemical splash caused another employee to become blind in one eye.

According to WorkSafe Victoria, the court was told Flame Safe Fabric Specialists had failed to provide adequate protective equipment and safety training to its staff.

Flame Safe Fabric Specialists was found guilty of ten charges under the Occupational Health and Safety Act 2004.

The two incidents, which occurred in 2007, involved the use and handling of corrosive chemicals that are classified Dangerous Goods.

WorkSafe Victoria says the first incident involved a worker losing sight in one eye after the handle of a bucket holding chemical liquid broke, causing liquid to splash into the man’s eye. The worker was not wearing eye-protection at the time of the incident and the safety spectacles provided to him were not fully enclosed.

The second incident happened when the handle on a dipper made from a metal rod attached with gaffer tape broke. This caused some of the mixture to splash into a worker’s face, burning him and numbing the inside of his mouth.

WorkSafe's acting executive director Stan Krpan says the case graphically illustrates the need for employers to take all possible steps to identify and remove hazards and ensure employees are properly trained.

Add a comment

Add a comment Comments

  • This is a clear breach of the OHS regulations. Is $135,000 enough of a fine to persuade a large chemical business to care about the safety of their employees. And if they can't afford a proper swizzle stick that's not held together with "a piece of Gaffa tape" what chance have the workers got of being kept safe. Recently where work there was an incident involving a chemical spillage of a mercury based solution, a small amount, but a spill nevertheless. Upon consultation of our chemical managagement system (chemwatch) we discovered that it told us we DID NOT require protective gloves to deal with this solution. We know that this product is dangerous and should not be handled without gloves and protective goggles! This is not the first time Chemwatch has FAILED at providing the correct information. If the worker above consulted an MSDS prior to dealing with this chemical it would've been ok, (unless it was a chemwatch document) Ridiculous.

    Sam Phillips | 10 May 2010 at 10:10

  • Thank you very much.

    Your comment has been submitted.

    Required

    Please enter your name.

    Required, but never displayed.

    Please enter a valid email address.

    Optional, and linked if provided.

    Required

    Please enter your comment.

    Required

    Please enter the code shown on the right.
    Check this box to receive the latest updates in our email newsletter.
    to get Safe To Work
    delivered to your inbox

    Recent comments

    Latest from Twitter

      Getting your tweets...